Control: 3 retracts, steering servo, and brakes (proportional braking)
Box measures: 55x30x15
The battery according to the retract model: up to 13V for ER-30 and ER-40, and up to 10V for ER-50
Maximum current per output: 2.5A
Programming Gear and Brakes:
Step #1 Upon receiving your unit, connect all three of the gear legs. Next, connect the inputs from your RX to your RB-45, Gear Inputs, Brakes (if applicable) Rudder Servo, and Rudder Input (steering servo).
Step#2 Now you must solder your power leads to a multiplex connector. You will notice there are three pins for the POS and NEG. It is recommended that you use the three pins for each lead. ( Better load distribution), CHECKING THE POLARITY TWICE following the label indications
Step#3 With your TX ON, hold the led button down and now turn on the power to your RX, and now release the led button. You will now get a single flash which indicates the start of the programming mode.
Step#4 Put the radio in the gear up position and repress the led button. You will now see two flashes on led.
Step#5 Put the radio in the gear down position, and repress led button. You will see three flashes and this will be the start of brake programming.
Step#6 Put the radio switch for brakes in the O% position and press the led button. You will now see four flashes.
Step#7 Put the radio switch for brakes in the 100% position and press led button again. You will see five flashes, ( configuration for rudder servo set up)
NOTE. If you do not have brakes, just press the led button twice to skip the calibration of the brake. You will see five flashes and now, press the led and this will set the steering servo position and complete the programming.
For a detailed video to help please visit this youTube video: