JR/DFA S3411 2K competition SYNC
The JR/DFA S3411 “Competition Servo” adds a CNC upper metal case increasing rigidity where it counts the most, the top of the servo.
Expect reduced stress and an overall longer life span of the gear train.
Also, this servo has metal B gear(second gear)
[Torque] 5.9 (6.0V) / 6.6 (7.4V)) / 7.5 (8.4V) kg･cm
81.7 (6.6V) / 91.7 (7.4V)) / 104.0 (8.4V) 0z･in
[Speed] 0.18 (6.0V)/0.16 (7.4V))/0.14 (8.4V) Sec/60°
[Dimension] 26.5mm x 15.0mm x 33mm
[Length of lead harness] 300mm
[Operating Voltage] 4.5V - 8.5V
· Wide Voltage
· Double ball bearings
■ programmable Neutral, endpoint, gain, etc(Works with PWM XBUS)120°150°180°(Works with PWM XBUS)
■ Super steel full metal gear(Gear B brass)
■ wide voltage
■ upper ball bearing (10x6) bottom(10x6)■Special design coreless motor
DFA is pleased to announce the release of our new XBus programmable servos, allowing not only serial servo connection but also individual servo programming with servo adjustments to suit every application.
These servos automatically detect the type of output they are plugged into - conventional receiver PWM outputs, or XBus. This means Programmable servos are XBus compatible, and also compatible with PWM receiver signals without any converter, allowing modelers to use conventional receiver systems.
* Compatible receiver systems: DMSS · DSMJ · 72MHz · 40MHz
When used on a DFA JR XBus system, the Programmable servos can be programmed in ways not previously possible. No additional programming device is necessary these servos can be set up using a DFA 8+6 DFA T44,JR XG series transmitter.
Changes made to servo programming are immediately apparent. Not only can servo direction and travel be adjusted, but it is now possible to fine-tune servo gain, dead band, and boost to suit your aircraft and desired response. This precise setup allows servo hunting to be eliminated and precise feel maintained.
* Double ball bearings
* Slow start function
*Compatible with any radio using PWM control
*XBus compatible allowing *120 to 180 deg travel
* feature you can adjust Dumping, Hold, Deadband...etc
* Do not use this servo under the different voltage other than specified
* If used on a large and Heavy control surface
*Try to adjust Dumping. Hold.
Dead band.Boost etc... You will set it up in perfect condition. (use RX Xbus port and Xbus TX)